Kenwood TM-281A - Manual (Page 11)

4
1
2 Connect the transceiver’s DC power connector to the
connector on the DC power cable.
• Press the connectors firmly together until the locking tab
clicks.
Note:
◆ For your transceiver to fully exhibit its performance capabilities,
we recommend using the optional PS-60 (22.5 A, 25% duty
cycle) power supply.
◆ Before connecting the DC power supply to the transceiver, be
sure to switch the transceiver and the DC power supply OFF.
◆ Do not plug the DC power supply into an AC outlet until you
make all connections.
F IXED S TATION O PERATION
In order to use this transceiver for fixed station operation,
you will need a separate 13.8 V DC power supply (not
included). The recommended current capacity of your
power supply is 14 A or more.
1 Connect the DC power cable to the regulated DC
power supply and ensure that the polarities are correct
(Red: positive, Black: negative).
• Do not directly connect the transceiver to an AC outlet.
• Use the supplied DC power cable to connect the
transceiver to a regulated power supply.
• Do not substitute a cable with smaller gauge wires.
To AC outlet
Regulated DC
power supply
Black (–)
Red (+)
Fuse holder
Fuse holder