Kenwood DNN991HD - Manual (Page 130)

129
Return to the Top page
Camera Control
When a CMOS-3xx (optional accessory) is
connected, the camera can be controlled
from this unit.
Preparation
• [NAV Key Longer than 1 Second] must be set to
“CAM”. See User interface (P.131) .
Camera Control
You can adjust the camera angle of the
camera system and display of the guideline.
1
Press the <NAV> button for 1 second.
HOME 6
Camera view screen appears.
2
Adjust each item as follows.
1 2
3
1 Guideline
Pressing each time turns on or off the
guideline display alternately.
2 Angle
Pressing each time changes camera angles in
the following order:
Super wide view/ Wide view/ Overhead view/
Wide view + Top view/ Corner view
3
Clearing the Camera View display.
Switching the View Camera
Switching between the front view camera
and the rear view camera.
1
Press the <NAV> button for 1 second.
HOME 6
Camera view screen appears.
2
Touch illustrated area during Camera
view screen.
Switches between the front view camera
and rear view camera each time you touch
the illustrated area.
ñ
C
amera Control