Kenwood TM-281A - Manual (Page 49)

42
8
U SING P RIORITY S CAN
1 Press [F], [MENU] and turn the Tuning control to
select Menu No. 12 (PRI).
2 Press [MENU] and turn the Tuning control to select
“ON” or “OFF” (default).
3 Press [MENU] to store the setting or any other key to
cancel.
• “PRI” appears.
4 Press any key other than [MENU] to exit Menu Mode.
• The transceiver checks for a signal on the Priority
Channel every 3 seconds.
• When the transceiver detects a signal on the Priority
Channel, “Pr” blinks and the frequency changes to the
Priority Channel.
• If you do not operate any control or key for 3 seconds
after the signal drops, the transceiver returns to the
original frequency and resumes Priority Scan.
Note:
◆ If you clear the Priority Channel {page 31}, Priority Scan stops.
◆ Priority Scan temporarily stops while the transceiver is
transmitting.
MEMORY CHANNEL LOCKOUT
You can lock out Memory Channels that you prefer not to
monitor during Memory Scan or Group Scan {page 40}.
1 Press [MR] and turn the Tuning control or press
Mic [UP]/[DWN] to select the Memory Channel to be
locked out.
2 Press [F], [MENU] and turn the Tuning control to
select Menu No. 14 (L.OUT).
3 Press [MENU] and turn the Tuning control to select
“ON” or “OFF” (default).
Memory Channel Number
4 Press [MENU] to store the setting or any other key to
cancel.
5 Press any key other than [MENU] to exit Menu Mode.
• The “ ” icon appears below the Memory Channel
number, indicating the channel is locked out.
6 To unlock the Memory Channel, repeat steps 1 ~ 5,
selecting “OFF” in step 3.
• The “ ” icon disappears.
Note:
◆ The Program Scan channels (L0/U0 ~ L2/U2), Call Channel and
Priority Channel (Pr) cannot be locked out.
◆ Even if a Memory Channel is locked out, you can perform Call
Scan {page 41} between the Call Channel and Memory Channel.