Siemens KF18WA41IE - Manual (Page 6)

6
Installation
Please detach the illustrated centre pages
before reading the installation instructions.
You can now read the text in conjunction
with the illustrations.
Installation location
Install the appliance in a dry, well
ventilated room. The appliance should not
be installed in direct sunlight or near
a heat source (e.g. radiator, cooker).
If required, use an insulating plate or
observe the following minimum distances
from the heat source.
3 cm to an electric cooker.
from an oil or solidĆfuel cooker 30 cm.
Installing the appliance
A Torx T 20 screwdriver is required for
installation.
The required fixtures are enclosed with
the appliance.
Important!
To protect the glass door, do not remove
the transportation protection devices until
the appliance has been placed in the
cavity, Fig. 5.
If installing the appliance in a room divider,
line the rear of the installation cavity in the
area of the appliance.
1. Carefully align the highĆsided unit
with a spirit level, Fig. 1/1. The
highĆsided unit must be screwed
securely to the adjacent units, Fig.
1/2, or to the wall, Fig. 1/3.
2. The appliance must be ventilated
by an opening in the base and a
duct at the rear of the highĆsided
unit Fig. 2.
Minimum crossĆsection of the
ventilation openings in the base
and duct: 200 cm
2 .
3. Install the power cord and pull into
the required position with a piece
of string, ensuring that the socket
is accessible after the appliance
has been installed. Slide appliance
into the highĆsided unit. Do not
trap the power cord Fig. 3.
4. When the door is open, insert the
cover strip into the sheetĆmetal
brackets on the housing, Fig. 4/1.
Screw on the cover strip with the
enclosed screws, Fig. 4/2.
en