Siemens KF18WA41IE - Manual (Page 7)

7
5. Remove the transportation
protection devices:
Unscrew the screwedĆon parts,
Fig. 5/1.
Remove the gluedĆon
transportation protection devices,
Fig. 5/2. Hold the plastic part, do
not press on it. Take hold of the
tab and slowly pull out the strip
straight and parallel to the base.
Fit enclosed cover to the housing,
Fig. 5/3.
Attach magnet, Fig. 5/4.
6. Insert the enclosed cavity fixture,
Fig. 6/1 into the housing.
Adjust the profiled strip, Fig. 6/2,
to the inside height of the
highĆsided unit and glue to the
housing on the door opening side.
If the side panels of the highĆsided
unit are 16 mm (or thinner),
separate the enclosed spacers,
Fig. 6/3, and insert into the hinge
arms.
7. Push the appliance into the highĆ
sided unit until the stop bar at the
top, Fig. 7/1, and the stops on the
door hinges, Fig. 7/2, are situated
on the front edge of the highĆsided
unit. Move the hinge side of the
appliance right up to the side panel
of the highĆsided unit.
8. Screw the appliance to the side,
Fig. 8/1, to the top, Fig. 8/2,
and to the bottom, Fig. 8/3,
of the highĆsided unit.
Insert the caps, Fig. 8/4.
9. Loosen the screws, Fig. 9/1, and
align the door. Retighten the
screws. Push the caps, Fig. 9/2,
onto the hinges.
10. Attach the door handle, Fig. 9/3
To prevent damage, the door
handle is enclosed loosely with the
appliance.
Electrical connection
The socket should be freely accessible,
preferably above the highĆsided unit.
Do not operate the appliance until it has
been installed.
When sliding the appliance into the
highĆsided unit, do not pinch the power
cord.
Connect the appliance to 220ć240 V/
50 Hz alternating current via a correctly
installed earthed socket.
The socket must be fused with a 10 A
fuse or higher. If the appliance is to be
operated in a nonĆEuropean country,
check on the rating plate whether the
indicated supply voltage, current type and
frequency of the appliance correspond
with the specifications of your power
supply. The rating plate is situated in the
bottom leftĆhand side of the appliance.
The power cord may be replaced
by an electrician only.
Installation dimensions
Fig. 0
en