Scan – Kenwood TK-7360E User Manual

Page 12

Advertising
background image



t

rAnSmitting

/ r

eceiVing

1

Select your desired zone and channel.

2

Press the microphone PTT switch and speak into the microphone to transmit.

Release the PTT switch to receive.

• For best sound quality at the receiving station, hold the microphone approximately

.5 inches (3 ~ 4 cm) from your mouth.

SCAN

Scan monitors for signals on the transceiver channels. While scanning, the

transceiver checks for a signal on each channel and only stops if a matching

signal is present. There are two types of scans available.

• Single Scan: Monitors the channels of only the currently selected zone. If set up to

scan the Priority channel, it will be scanned even if it is not in the selected zone.

• Multi Scan: Monitors the channels of every zone.

To start/stop scanning, press the key programmed as Scan.

• “SCAN” and the icon appear on the display during scan.

• When a signal is detected, scan pauses at that channel. The transceiver will remain on

the busy channel until the signal is no longer present, at which time scan resumes.

Note:

To use Scan, there must be at least 2 channels added to the scan sequence.

c

hAnnel

r

ecAll

During scan, you can recall the last zone and channel/group ID on which you

made a call by pressing the key programmed as CH/GID Recall. Scan will

remain paused on the Recall channel until you press the key again.

p

riority

S

cAn

If a Priority channel has been programmed, the transceiver will automatically

change to the Priority channel when a call is received on that channel, even if a

call is being received on a normal channel.

• The icon appears on the display when the Priority channel is selected.

t

emporAry

c

hAnnel

l

ockout

During scan, you can temporarily remove specific channels from the scanning

sequence by pressing the key programmed as Scan Delete/Add while Scan is

paused at the undesired channel. To temporarily remove a zone, press and hold

Scan Delete/Add

while Scan is paused at a channel in the undesired zone.

• The channel/zone is no longer scanned. However, when scanning is ended and

restarted, the Scan settings return to normal.

Advertising
This manual is related to the following products: