Kenwood CMOS-200 - Manual (Page 6)

6 | CMOS-300/CMOS-200
– +
2A 2A
CAMERA
REVERSE
CAMERA
ACC
Video cord: 1.5m (59.1 inch)
Navigation system/video monitor
(separately available)
Power supply box
GND cord (Black): 1 m (39.4 inch)
Accessory cord (Red): 1 m (39.4 inch)
Reverse detection cord (purple/white): 10 cm
(3.94 inch)
GND
Battery
Main fuse
Fuse
Engine key
Connect to a metallic part of vehicle (a part of chassis
connected to the negative side of power supply).
When the monitor does not have the
rearview camera input and switches the
input upon detection, connect to vehicle's
reverse lamp harness.
CAUTION
・ If the engine key of your vehicle does not have the ACC position, branch the wire energized when the
engine key is ON and connect it to the accessory power cord.
・ Before proceeding to connections, make sure that the engine key is not inserted and disconnect the ( -)
terminal of the battery to prevent the short-circuiting incident.
Connect to the ON-OFF switchable power supply. Do not
connect to a permanently ON power supply.
Fuse (2A)
Camera
Camera connection cord
Connect the camera to the camera connection cord.
Connect to the rearview camera video input or to the
external video input of the video monitor.
Power cord
Accessory power
(ACC)
Switch unit (CMOS-300 only): 2 m (78.7 inch)
Basic Connections
Not used when connecting to a navigation system
or monitor with a dedicated rearview camera video
input.
Camera’s cord length : 5 m (197 inch), Camera connection cord
length : 3 m (118 inch)
Connections
$AKPFD