Asante Technologies FS4008E/FS4016E - Manual (Page 17)

Mounting Configurations
Page 2-7
Wall Mounting the FS4002E, FS4004E, and FS4008E
The FS4002E, FS4004E, and FS4008E come with a wall-mount kit. The kit
consists of screws and wall anchors.
▲ Important! The FS4016E cannot be wall-mounted without
the optional wall mount kit, part number 99-00486--07.
To mount the FS4002E, FS4004E, and FS4008E on a wall, consider the
following when selecting a site:
❑ Select a site that is free of obstructions from other equipment or
devices
❑ Place the Switch high enough to easily observe LED indicators and to
allow for easy power and cable access
❑ Decide how you want the orientation of the front panel.
To mount the FS4002E, FS4004E, or FS4008E on a wall:
1
Measure the screw holes on the bottom of the Switch.
2
Drill two holes into the wall equalling the same distance as
measured in step 1.
▲ Important! Drill the holes only to the depth of the screw’s
length. If the holes are too deep, the mount may not be
secure.
3
Insert the plastic anchors (supplied) into the drilled holes
and gently tap them in with a hammer.
4
Insert and turn the screws (supplied) into the plastic
anchors, leaving a small portion of the screws sticking out.
▲ Important! If the screw head is too high and the unit stands
too far off the wall, accidental pressure could cause screw
heads to press into the circuit board, and result in damage.
5
Lift the Switch and align the slots on the bottom of the
Switch with the screw anchors.
6
Gently slide the Switch onto the screws.
The Switch wall mounting is complete. The Switch is ready
for network connections.