Kenwood DNX9260BT - Manual (Page 46)

46 DNX series DNX9260BT/ DNX7260BT
3 Speak the command
Speak the command. (Ex: Speak "TUNER".)
You will hear a beep.
The screen has changed to the Tuner
Control screen.
You will hear a beep again.
4 Control the source with voice control
Repeat the same procedure as step 2
or 3.
For information on the voice commands,
refer to <Voice command table>
(separate volume).
5 End the voice control mode
Press the TALK switch.
⁄
• The voice control is disabled when is
displayed on the upper-right corner of the
screen.
• The voice control is canceled when the screen
is touched or any of the buttons, except the
[VOLUME] button, on the front panel or the
remote control unit is pressed.
• The voice control is disabled while talking on
the phone with hands-free.
Voice Control (DNX9260BT only)
The unit is equipped with Advanced Speech Recognition function which allows you to
operate it with your voice. The supported languages are US English, UK English, French,
German, Dutch, Italian, and Spanish. For information on the voice commands, refer to
<Voice command table> (separate volume).
• ASR on the Language Setting screen should be set to "Enabled". See <Language Setting> (page 70).
Voice Control Voice Control
1 Enter into the Voice control mode
Press the TALK switch.
The buttons enclosed in a green square
support the voice control.
2 Speak the command
Speak the command. (Ex: Speak "Top
Menu".)
You will hear a beep.
The screen has changed to the Top Menu
screen.
You will hear a beep again.
B64-4676-00_01_E_English.indd 46 B64-4676-00_01_E_English.indd 46 10/02/05 15:27 10/02/05 15:27