Aussie Kanga - Manual (Page 28)

· Wash the porcelain coated Cooking Grids (41) with a
mixture of hot water and baking soda.
· Empty the foil pan and grease tray after each cooking
session so excessive grease does not accumulate.
Failure to remove grease may result in grease
dripping onto the cart and/or a grease fire in the
tray.
· Open Lid or Hood (depending on the model) before
lighting the grill to prevent an explosion from gas
build- up.
· The Lid (KangaTM series only) must never cover the
cooking surface while the LP gas grill is in use or hot.
· Always inspect the gas hose and regulator assembly
before each use. If the hose is cut, damaged, or
shows signs of excessive abrasion or wear, do not
use the LP gas grill. Contact the manufacturer, as the
hose and regulator assembly must be replaced with
an assembly specified by the manufacturer prior to
further use of the LP gas grill.
3) From the “Off” position, push control knob in on the left
burner and turn counter-clockwise until you feel resistance.
Pause 4 seconds, then continue turning the control knob
until a click is heard and the burner is lit.
4) Light the remaining burners by turning the control knob
counter-clockwise. Your grill has a crossover ignition system
that allows the burners to light successively off one another.
Confirm each burner is lit before lighting another burner.
5) If any of the burners do not light, repeat Step 3. The burner
should light within three or four attempts. If burner still does
not light, try the next burners from left to right.
WARNING: If any or all burners fail to light after
following Steps 3 & 4, turn all knobs to the “off”
position and close the valve on the LP gas cylinder.
Wait five minutes; then repeat all of the above lighting
procedures.
Note:If the burners still fail to light, refer to the
Troubleshooting page. The burner can be lit manually, see
Manual Lighting of the Grill.
6) After ignition, preheat the grill by turning the control to
“High” position for 3-5 minutes. The grill should be
pre-heated before every cooking session. The hood
(Bonza™ series only) should be closed during
preheating. The lid (Kanga™ series only) must never
cover the cooking surface while the grill is in use or
ishot.
WARNING: If a burner goes out during the cooking
cycle, turn all knobs to the off position and close the
valve on the LP cylinder. Open hood (Bonza™ series
only) and wait five minutes before attempting to relight
the grill.
Preparation Before Cooking
Lighting the Grill Using the Integra-
Spark Ignition System
28
2. Turn LP cylinder handle
counter-clockwise - “ON”
1. Open lid or hood (depending on model)
3. Push in and turn control knob
counter-clockwise until you feel
resistance, wait 4 seconds then
continue until a click is heard
and the burner is lit.
How to light your LP gas grill (See diagram below
for illustrations)
1) Open Lid or Hood (depending on the model)
2) Important: Make sure control knobs are turned
“off” first. Open the LP gas cylinder valve by turning
the valve handle counter-clockwise until it stops.