Teledex Y Series - Manual (Page 12)

12 www.teledex.com Y SERIES EXA100 USER GUIDE
5.2.1 ADVANCED WIRELESS
Field Description
BG Protection
Mode It provides 3 options,
including Auto, On, and Off.
The default BG protection
mode is
Auto.
Beacon Interval The interval time range
is between 20 ms and
999 ms for each beacon
transmission. The default
value is 100 ms.
Date Beacon
Rate (DTM) The DTM range is between
1 ms and 255 ms. The
default value is 1 ms.
Fragment
Threshold This is the maximum data
fragment size (between 256
bytes and 2346 bytes) that
can be sent in the wireless
network before the router
fragments the packet into
smaller data frames. The
default value is 2346.
RTS Threshold Request to send (RTS)
is designed to prevent
collisions due to hidden
nodes.
An RTS defines the biggest
size data frame you can send
before an RTS handshake is
invoked. The RTS threshold
value is between 1 and 2347.
The default value is 2347.
If the RTS threshold value is
greater than the fragment
threshold value, the RTS
handshake does not occur.
Because the data frames
are fragmented before they
reach the RTS size.
Tx Power The Tx Power range is
between 1 and 100. The
default value is 100.
Short Preamble Select Disable or Enable.
Field Description
Short Slot Select Disable or Enable.
Tx Burst Select Disable or Enable.
Pkt_Aggregate Select Disable or Enable.
IEEE802.1 H
Support
Select Disable or Enable.
Country Code Select the region which you
are in. It provides six regions
in the drop-down list.
5.2.2 WI-FI MULTIMEDIA
Field Description
WMM
Capable Enable or disable WMM.
APSD
Capable Enable or disable APSD.
DLS Capable Select Disable or Enable.
WMM
Parameters
Click the WMM Configuration
button to pop up the WMM
Parameters of Access Point
page. You can configure WMM
parameters on the page.
Multicast-to-Unicast Converter: Enable or
disable Multicast-to-Unicast Converter.
After completing the settings above, click Apply to
save the settings and make the new configuration
take effect. Click
Cancel to close without saving.
5.3 Security
Choose Wireless Settings>Security and the
following page will be displayed. It allows you
to modify the settings to prevent unauthorized
accesses.