Videotec VERSO POLAR - Manual (Page 11)

EN - English - I
nstruc
tions manual
9
g h When the circuit is powered by an external
source care must be taken to the type
of voltage used and, depending on
requirements, to the correct power supply
kit. When installing the optional camera
power supply it is not necessary to remove
any previously installed component.
6.1.6 How to install the blower
g h Not applicable to housings with installed
cooling device.
g h The terminal board marked J4 can be used
to take off the main power supply voltage
coming from an external source. When the
circuit is powered by an external source
care must be taken to check the type of
working voltage and use the correct power
supply kit, according to requirements.
g h The blower kit should be assembled
according to the instructions (Fig. 05) to
ensure a correct air circulation inside the
housing.
This chapter describes how to install the blower
kit option into the housings that are not equipped
with it. The blower kit can be supplied in 3 different
configurations depending on the power supply
voltage.
Open the housing as described before.
Fix the blower inside the body of the housing, using
the corner bracket and the supplied screws. One
positioning option is possible for the 420mm version
(01) and 2 for the 360mm version (02).
01
02
Fig. 10
Insert the 2 pin connector at the end of the cable into
the corresponding one indicated by J6 (FAN) on the
support circuit (Fig. 05, page 8 and Fig. 06, page 8).
6.1.5 How to install the camera power
supply
g h Not applicable to housings with installed
cooling device.
This chapter describes how to install the camera
power supply option into the housing. There are
2 types of camera power supply depending on
requirements. One model has an input voltage from
100-240Vac with an output voltage of 12Vdc, 1A.
The other has an input voltage of 115/230Vac and an
output voltage of 24Vac, 400mA.
Fig. 07 IN 100-240Vac - OUT 12Vdc.
Fig. 08 IN 230Vac - OUT 24Vac.
Open the housing as described before.
Position the camera power supply in the provided
seating (Fig. 04, page 8) parallel to the support ribs.
Fig. 09
Fix the power supply to the body of the housing
using the corner bracket and screws supplied in the
camera power supply kit.
Insert the 6-pin connector at the end of the cable
into the correspondent one on the support circuit,
identified by J5 (Fig. 05, page 8 and Fig. 06, page 8).
Close the housing.