Videotec VERSO POLAR - Manual (Page 12)

EN - English - I
nstruc
tions manual
10
To guarantee the IP44 weatherproof, install the
housing on the support following the inclination
limits as shown in the picture.
0˚
45°
45°
Fig. 12 Maximal rotation on the transversal axis: 0˚.
Maximal inclination on the longitudinal axis: +/- 45˚.
Open the housing as explained above.
Make the electric connections for the cooling device
to the terminal marked J8 FAN.
J5 - Camera
OUT J2 - OUT J1 - IN
J3 - Heater
J7 - Power supply
J8 - Blower
Fig. 13
In this circuit the camera can be powered from the
terminal marked J2. The power for the optional
heating system can be taken from the terminal
marked J3 HEATER ("6.1.3 Connection to the power
supply line", page 7).
Close the housing following these instructions in
reverse.
g h If the circuit is powered from an external
source, pay special attention to the voltage,
as the housings with this device must only
be powered with 12Vdc or 24V AC voltage.
6.1.6.1 100-240Vac power supply
Install the camera power supply supplied with the
blower kit as described in the chapter "6.1.5 How to
install the camera power supply", page 9.
Close the housing.
6.1.6.2 12Vdc or 24Vac power supply
In this housing the blower kit is supplied with a
connector fitted with the appropriate connections to
make the support circuit compatible with operation
at the power supply voltage available. This connector
should be inserted into the correspondent one
marked J5, on the supplied circuit.
Close the housing.
6.1.7 Cooling device
This section describes how to connect the housing
with installed cooling device.
No other components need installing inside these
models, as each one is supplied complete with all the
necessary parts.
Special attention must be paid to the position of the
air intake filter fins when installing the housing.
IN
OUT
Fig. 11
Depending on the inclination of the housing, the
direction of the fins must be such to prevent water
entering in case of rain.