Videotec VD18T1 - Manual (Page 15)

Page 3 MNVCVD18T1_4604
3 Identification data
On the video distributor VD18T1 there are two plates complying with EC specifications.
The first plate includes:
• Model identification code (Extended bar code 3/9 )
• Mains voltage (Volt)
• Frequency (Hertz)
• Power consumption (Watt)
The second plate shows the model serial number (Extended bar code 3/9)
When installing the appliance, check that the power supply specifications of the video distributor correspond to
those required. The use of improper appliances may seriously compromise the safety of the personnel and the
installation.
4 Description of VD18T1 unit
The VD18T1 unit is a video distributor. It distributes the input video signal (for example coming from a
camera) to a series of video outputs (to which monitors can be connected) without loss of signal quality.
The video distributor VD18T1 is mounted in a metal case, coated with epoxy powder.
4.1 Features
• 1 composite video input
• 8 composite video outputs
5 Installation
The installation must be carried out only by qualified technical staff.
The following procedures must be carried out with power supply off, if not otherwise specified.
5.1 Unpacking
If the packing shows no relevant defects (due to falls or anomalous abrasions), check the material contained,
according to the list given at paragraph Packing contents chapter Introduction.
The packing materials can be completely recycled. The installer technician is required to dispose of them
according to the differentiated collecting modalities or ,anyway, according to the normative laws in force in the
Country of use.
5.2 Check of identification data
Before installing the appliance, check that the material supplied corresponds to the specifications
indicated on the data plate, following the chapter Identification data. Do not carry out any modification or
connections which are not provided for in this manual: the use of improper appliances may seriously
compromise the safety of the personnel and the installation.