Videotec SM82A - Manual (Page 65)

Page 27 MNVCSM42A_0408
[READ THIS CAREFULLY 6.1]
[----------------------------]
[ If a new password is ]
[ inserted and forgotten ]
[ this setup procedure ]
[ will be unaccessible ]
[ and the system locked. ]
[ ]
[ ]
[ Procede to change pwd? ]
[ ENTER.Yes ]
[ CLEAR.No ] Change password submenu
Entering the change setup password submenu will show a warning message
on the screen, shown on the screen to the left. Be very careful because if a
password setting is lost it will be necessary to contact the supplier to reset the
whole system and all the data will be lost.
The instructions for changing the password are shown on the screen.
[VIDEO MASK 7]
[----------------------------]
[ ]
[ Camera no.1 ]
[ ]
[ ]
[ ]
[ ]
[INC/DEC.Camera Change ]
[ENTER.Show/Change ]
[ ]
[SEQ.End ] Masking submenu
Masking is a system for hiding part of the image when this comes from fixed
cameras. If part of the image supplied by the camera is to be covered it should
be masked.
Choose the camera to be masked using
8
and
9
. Press

to view the
preset mask and modify it if necessary. A typical screen is shown in the
following example.
[ ********** ]
[ ********** ]
[ ********** ]
[ ********** ]
[ **##****** ]
[ **##****** ]
[ ]
[ CAMERA 1 ]
[ -------- ]
[ 1
ļ2 3Ľ4 ]
[ Enter Ż Ź]
[ SEQ. Fine]
Submenu for Masking: modify
The example on the left * shows the current mask for camera 1, # indicates the
cursor, which can be shifted using the left
!,
right
",
up,
#
down
$
keys, or by moving the joystick if the matrix is controlled by a DCJ or DCT
keyboard.
Press

to mask /remove the mask under the cursor.
Pressing the
(
key twice quickly will completely remove the mask on the
video signal.
Press
8
and
9
to select another input video.

confirms the changes made to the masks of the various input videos.