Audiovox APS-92BT-CL - Manual (Page 3)

6. Move the valet/bypass switch on, then off again.
7. The dash mounted L. E. D. will flash 2 times, and the siren will "chirp" one time,
indicating that the system is ready to accept programming for channel 2, or the pulsed
ground output for remote trunk release, remote car starter, etc.
8. You can assign any one of the two remaining button functions listed in 4a, 4b, or 4c
above to operate channel 2. You cannot use the button(s) that operate channel 1,
selected in step 5, to operate channel 2.
9. Press and hold the selected choice. The siren will emit a long "chirp" to confirm that
programming of channel 2 was successful.
10. Move the valet/bypass switch on, then off again.
11. The dash mounted L.E.D. will flash 3 times, and the siren will "chirp" one time,
indicating that the system is ready to accept programming for channel 3. (PS 30i)
12. Press and hold the remaining transmitter button function. The siren will emit a long
"chirp" to confirm that programming of channel 3 was successful.
13. To exit program mode, either turn the ignition key to the off position, or move the valet
switch on then off one additional time. This is indicated by a long "chirp" from the siren.
You can program any individual channel, without reprogramming all channels, by following
the quick reference chart below.
QUICK REFERENCE:
1 Flash
2 Flashes
VALET SWITCH L.E.D. CHANNEL
1
3 Flashes 3
2
ON then OFF 5 Times
ON then OFF 4 Times
ON then OFF 3 Times
After the desired channel is programmed, turn the ignition key to the off position to exit
programming mode.