Typical intellicat installation version 2.xx – MagTek IntelliCAT99875659 User Manual
Page 4
<IntelliCAT>| <Installation User Support Document>
Typical IntelliCAT Installation version 2.XX:
Software Installation:
Login as PC Administrator
Mandatory: Turn Off Windows User Account Control (UAC) in Control Panel, under Users during the
install. Once the IntelliCAT installation is working properly, turn UAC back on if required by your
institution.
Do not connect Hardware until Device Drivers are installed! When installing the IntelliCAT Software
(ASM PC Software Suite Rev 2.XX) & the drivers (USB & MCP) to newer O.S.’s such as Vista and
Windows 7 (if downloading the drivers) make sure to Right-Click the .exe download and under
properties select UNBLOCK, and always Right-Click and install the .zip. .bat or .exe files and RUN-AS
ADMINISTRATOR!
Go to Folder Options in Control Panel and uncheck “Hide Extensions for known file types”
DISK#1 - USB DRIVER INSTALLATION
Download and unzip the installation
package from
to the C:\MT3410 folder. Navigate to the appropriate folder to complete the driver installation
Right click, Run the Install.bat file as Administrator from the appropriate 32bit or 64bit folder. Plug
in the IntelliPIN, wait for the driver to install and view it in Device Manager listed under Ports.
Make a note of the port assignment.
DISK#2 - INTELLICAT ENCODING SUITE INSTALLATION
Browse to the CD and install each module in the following order. Right-Click Setup.exe in each
folder and RUN-AS ADMINISTRATOR! Follow the exact order as noted below.
INSTALL:
Common
(Note: Always Install Common FIRST)
DataEntry
Administrator
KeyInjection
Controller (optional) if multiple workstations within a branch share a Motorized IntelliCoder and Win
7 32bit PC’s are in use.
Note: Win 7 64bit - Check the date code on the bottom of each Motorized IntelliCoder prior to
installing Controller. If the Date precedes January 1, 2008, DO NOT install the Controller
module.
Designer (optional) main office only
DISK#3 - MCP DRIVER INSTALLATION
Download and unzip the installation package from
to the C:\Temp\MagTek\MCPDriver folder. Navigate to the folder to complete the driver installation.
Right-Click and install the .zip or .exe file and RUN-AS ADMINISTRATOR!
Run the executable Setup.exe from the DISK1 folder –
Mandatory – ACCEPT ALL DEFAULTS.
When prompted, reboot the PC.
***Do not plug in the Motorized IntelliCoder until the reboot is complete