MagTek IntelliCAT99875659 User Manual
Page 5
<IntelliCAT>| <Installation User Support Document>
Log back in as the Administrator and plug in the Motorized IntelliCoder. Wait for the driver to install
and view it in Device Manager listed under Ports. If the (IntelliStripe 380 (Com#)) is present, this
indicates the O.S is a 64bit User Mode install. Make a note of the port assignment.
If the IntelliStripe 380 (com#) is not present under Ports, it will be listed in Device Manager under the
Universal Serial Bus Controller Section as IntelliStripe 380 USB. This indicates the O.S is a 32bit
Kernel Mode install. In either a 64bit of 32bit install, the IntelliStripe… is present under the Universal
Serial Bus Controller section. Make sure there are no yellow exclamation marks or question marks
on the installed devices.
IMPORTANT NOTE: If installing to a Win 7 64bit PC, it is mandatory to follow the steps in the
document entitled IS380 Win ASCII mode, to configure MCP. Motorized IntelliCoders must be older
than January 1, 2008 to switch to ASCII mode.
CONFIGURATION OF THE INTCAT.INI FILE:
COPY the INTCAT.INI located in C:\Windows\ from the Old PC and PASTE it to the desktop
on the new PC for review and use with the new IntelliCAT installation.
Refer to the 99875658-1.01 IntellICAT MigrateWin7 document for configuration instructions and
for saving important files for use with the reinstall to a new Vista 32/64 or Win 7 32/64bit PC.
ACTIVATION OF INTELLICAT SOFTWARE MODULES
Email the challenge number from the Data Entry registration page to
or call
888-624-8350 for activation of each of the other Software Modules. MagTek Support will provide the
entire IntelliCAT module activations based on the challenge number provided. Do not close the Data
Entry module until the activation codes are received via email or phone.