MagTek IntelliCAT99875662 - Manual (Page 6)

<IntelliCAT>| <Installation User Support Document>
If the IntelliCAT Controller module is used and the Motorized IntelliCoder is newer than January 1,
2008, go to Step 5. If only the Data Entry module is used, Skip Step 5 but switching to the ASCII
mode is highly recommended in a 64bit environment.
*******If the date code on the bottom of the Motorized IntelliCoder is dated before January
1,2008, DO NOT FOLLOW Step 5 and attempt to use the Switching Protocol as the Motorized
IntelliCoder may suffer an unrecoverable error and require a chargeable repair.
5. 5. Open the MCP Protocol Switch Utility, go to the download location on the PC where the
MCP driver was installed and navigate to the SystemFolder. This folder should be located at
C:\Program Files (x86)\MagTek\SystemFolder. Locate the MCPProtocolSwitch.exe. Right-Click on
the file and Run-as Administrator. Click the about button; the following version should display.
A. Set the COM# to match what is identified in Device Manger, Ports for the IntelliStripe 380
device. The following Example is set to COM4
IntelliStripe 380
B. Use the “Detect Current Mode” to verify the device is first in Standard MCP Mode as shown
above.