MagTek IntelliCAT99875662 - Manual (Page 7)

<IntelliCAT>| <Installation User Support Document>
C. After detection, click the button “Switch to ASCII Mode” & once confirmed under Status at
the top, click CLOSE on the lower right as show below.
IntelliStripe 380
D. Go back to the Windows Desktop top MCP shortcut and Right-click and select Run- As
Administrator. Verify that the settings are the same as they were in Step #3 above and now
check the ASCII option to change the Protocol selection to ‘ASCII’ and click OK, once, to set the
new protocol.
E. Open the IntelliCAT Data Entry.exe and verify a successful log in (after activating via
[email protected] or by calling 888-624-8350) with the IntelliPIN, Operator card, and
password. Once logged in, ensure there is a solid green LED light on the front of the Motorized
IntelliCoder.
F. Log off as administrator and have a regular user log in. Follow Step E above to ensure there
is a solid green LED light on the front of the Motorized IntelliCoder. If the light turns solid
green, MCP is configured properly.