MagTek P-SERIES TTL - Manual (Page 9)

3
SPECIFICATIONS
Specifications for the Readers are listed in Table 1-2.
Table 1-2. Specifications
ELECTRICAL
Input Voltage +5 VDC
±10%.
Current Draw: Less than 12 mA
MTBF: Electronics: 125,000 hours. Head: 1,000,000 passes
(500,000 insert cycles)
Output Signal Levels V
ol
= 0.4 V @ 2.0 mA
V
oh
= V
cc
– 0.5V @ 2.0 mA
Interface: TTL level.
Dielectric Strength: DC250 volts, 1 minute
Insulation Resistance: Greater than 10 M ohms at DC 250V
(Measured between PCB ground and frame).
Mag-Stripe Read:
Recording Method:
Card Speed:
TK1:
TK2:
Two-Frequency Coherent Phase (F/2F).
3 to 50 IPS and 210 BPI (7.6 to 127 cm/sec)
75 or 210 BPI (MagTek decode ASIC is density independent).
75 or 210 BPI (MagTek decode ASIC is density independent).
MECHANICAL
Dimensions: Without Bezel With Extended Arm Bezel
Length: 4.08" (103.6 mm) 4.82" (122.4 mm)
Width: 3.15" (80.0 mm) 3.54" (90.0 mm)
Height: 1.29" (32.8 mm) 1.81" (46.0 mm)
Weight: 3.5 oz. (100 g
±20%)
I/O Connector Type: For P/N 21065114: 9-pin straight locking header, AMP P/N 640456-9
For P/N 21065117: Right angle 7-pin locking header, ITW Pancon
P/N MLAS100-7.
MSR read-data format
specifications supported: ISO/ANSI/AAMVA/CDL/ 75 or 210BPI on track 1 (normally 210 bpi)
ISO/ANSI/AAMVA/CDL/ 75 or 210BPI on track 2 (normally 75 bpi)
ENVIRONMENTAL
Temperature
Operating:
Storage:
-22
o
F to 140
o
F (-30
o
C to 60
o
C)
-22
o
F to 158
o
F (-30
o
C to 70
o
C)
Humidity:
Operating:
Storage:
10% to 90% non-condensing
10% to 90% non-condensing
Altitude
Operating:
Storage:
0 - 10,000 ft. (3,048m)
0 - 50,000 ft. (15,240m)