MagTek MT-215 TTL SINGLE OR DUAL HEAD - Manual (Page 11)

5
SECTION 2. INSTALLATION
This section describes cabling information, mounting dimensions and timing.
PIN LIST AND CONNECTORS
Table 2-1 lists the connector pins and the required mating Connector.
Table 2-1. J3 Pin List
Pin Number TK 1, 2
1 Rear Sensor
2 Data TK 2
3 Card Present
4 Strobe TK 2
5 No Connection (Index Pin)
6 VCC
7 GND
8
Strobe TK 1
9 Data TK 1
10 No Connection
11 No Connection
Mating Connector*: Molex 22-01-2091 or 22-01-2111 (recommended for keying purposes)
*Molex Terminals 08-50-0114; Molex Key 15-04-9209
MagTek P/N 21065113 uses a 9-Pin connector with the same signals with pins 10 and 11 removed