MagTek USB MagneSafe V5 Flash - Manual (Page 10)

Flash MagneSafe Swipe Reader
4
SPECIFICATIONS
Table 1-1 lists the specifications for the MagneSafe V5 Flash Reader. Figure 1-2 shows the
dimensions of the Reader.
Table 1-1. Specifications
Reference Standards ISO 7810 and ISO 7811; AAMVA*
Power Input USB port or 5 VDC for battery charging
Recording Method Two-frequency coherent phase (F2F)
Message Format ASCII
Card Speed 4 to 60 ips (10.1 to 152.4 cm/s)
Battery Characteristics 3.7V, 120 mAh Li-ion Polymer Battery
Time to Charge Battery About 2.5 hours (from a fully discharged state)
Card Swipes per Full Charge Over 100 swipes
ELECTRICAL
Current 100mA maximum during charge
MECHANICAL
Dimensions
Length 2.68” (68.07mm)
Width
0.65” (16.51mm)
Height 1.35” (34.29mm)
Weight 1.4 oz. (39.7 gr)
Cable length 6’
Connector USB Micro B
ENVIRONMENTAL
Temperature
Operating 32
°F to 113 °F (0 °C to 45 °C)
Storage -4
°F to 140 °F (-20 °C to 60 °C)
Humidity
Operating 10% to 90% noncondensing
Storage 10% to 90% noncondensing
* ISO (International Standards Organization) and AAMVA (American Association of Motor
Vehicle Administrators).
Figure 1-2. Dimensions for the Flash Reader