Waterloo F1878 - Manual (Page 3)

Process:
▪ Make sure drawers are fully closed.
▪ Insert the lockbar (which stores in the top tray), tabbed
end up, into the slot in the top tray and down into the slot
in the base.
▪ Close the cover and lock with the key.
TO LOCK CHEST
NOTE: Not all operation instructions will relate to your
model.
TO UNLOCK CHEST
• Reverse above procedure.
Process:
▪ Insert the lockbar into the slot in the base.
▪ Move the lockbar toward the unit until the bent end fits
into the slot near the lock.
▪ Lock with the key.
TO LOCK INTERMEDIATE CHEST
The lockbar for the intermediate chest is stored in the
top drawer.
TO UNLOCK INTERMEDIATE CHEST
▪
Reverse above procedure.
Process:
▪ Insert the straight end of the lockbar into the slot in the
base.
▪ Move the lockbar toward the unit until the bent end fits
into the slot near the lock.
▪ Lock with the key.
TO UNLOCK ROLLER CABINET
▪ Reverse above procedure.
NOTE: If your unit is equipped with a storage compartment
with a panel at the bottom, pull panel out, lift up and push
panel back into unit to gain access to compartment.
TO LOCK ROLLER CABINET
THE LOCKBAR FOR THE ROLLER CABINET IS
STORED IN A SLOT IN THE TOP FRONT CORNER OF
THE UNIT.
• Empty the drawer.
• Fully extend the drawer.
REMOVING DRAWERS
Lever Style - Lift or lower (depending on the slide) the
release lever on both sides, (this allows the slides to ride
over the stops.) Pull out to remove.
Tab Style - Depress the release tabs on both sides,
(this allows the slides to ride over the stops.)
Pull out to remove.
Friction Style - Fully extend the drawer. Insert screwdriver
into the slot in the side and push in on the stop until it
clears the lance. Pull drawer just past lance before
releasing stop. Repeat the process for the other slide.
3
OPERATION
Release