Waterloo F2002 User Manual
Page 5
REMOVING AND INSTALLING SLIDES
Slide Removal -
• The drawers in these units can be rearranged to fit your
specific needs. This means that drawers may be moved
or replaced as desired. For example, a 6-inch drawer
may be replaced by a 2-inch and a 4-inch drawer, or
three 2-inch drawers.
• First remove the drawer (Refer to Operation A).
• Lift and hold the spring retainer, and push the slide to-
ward the rear of the unit. The slide may now be removed.
Spring Retainer
Slide Installation -
• Place the slide in the appropriate position in the unit and
pull toward the front of the unit until the spring retainer
snaps into position and secures the slide.
• For smooth operation, make sure that the drawers are
matched with their original slides.
TROUBLESHOOTING
Problem
Cause
Solution
The unit unlocks
but the drawers
still will not open.
One or more
of the drawers
are holding the
lockbars from
releasing.
Completely close
all the drawers and
the lockbars will
release to open the
drawers.
The cover on the
chest is holding
the lockbars from
releasing.
Apply a downward-
pressure to the
top of the cover
to let the lockbars
release.
The release
cables are not
working.
In an UNLOCKED
position and pull
the lock lever sev-
eral times.
The unit is leaning
too far forward.
Position the unit on
a level area.
The unit locks but
some drawers still
are not locked.
One or more of
the drawers are
not compeletly
closed.
Unlock the unit.
Close all drawers
completely. Relock
unit.
LOCK SYSTEM
Figure 7
5