Wagner Paint-N-Roll Plus - Manual (Page 5)

5 English
3. Cleanup
Start
Returning excess material to material container
Cleaning the Paint N Roll™
1. Pull plunger back to draw
remaining material from
the roller arm assembly
into the tube.
1. Remove fill tube from the container
lid. Install end of the fill tube into the
valve housing.
4. Remove the roller arm. Submerge
the head of the Paint N Roll™ and
the fill valve and pull the plunger in
and out a minimum of 5 times.
2. Submerge the fill tube into the
appropriate cleaning solution
and pull the plunger in and out a
minimum of 5 times.
5. Clean the remaining parts (cap,
core, cover and spatter guard) by
hand using the appropriate cleaning
solution.
3. Remove the fill tube. Submerge the
fill valve and roller arm and pull the
plunger in and out a minimum of 5
times.
2. Press the fill valve
onto the fill tube. Push
plunger forward to return
excess material into the
container.
3. Remove the spatter
guard. Press locking tab
and remove roller cover
assembly from the roller
arm.
4. Remove the roller cap.
Push the roller core out
the other end. Place
spatter guard, cap, core
and cover in a bucket of
the appropriate cleaning
solution.
Before you begin cleaning:
When cleaning the Paint N Roll™, make sure
to use the appropriate cleaning solution for the
type of material used.
• If you used latex-based materials, use
warm, soapy water to clean the Paint N
Roll™.
• If you used oil-based materials, use mineral
spirits.
You will need:
• A large bucket or other container that will
hold cleaning solution.
TIP: A large laundry tub filled with warm,
soapy water is ideal for cleanup if you used
latex-based materials.
1
x5
1
4
x5
2
5
x5
3
2 3 4