Wagner SMART Power Roller System - Manual (Page 9)

9 English
Storage /
Maintenance
Start You will need:
• Petroleum jelly
• An old toothbrush or other similar cleaning
brush
Cleaning and Storage Tips:
• Thoroughly cleaning your unit and its
components is the best way to ensure the
prolonged life of your unit.
• Keep water, paint, and other residues away
from the handle button. A clogged handle
button will affect the performance of your
unit.
• Be sure that your unit is free from all fluids
before storage. After storing your unit in
extreme cold temperatures, allow unit to
reach room temperature before using.
• When storing your unit, be sure the paint
hose is stored in a large loop without any
kinks. If it is bent, it could be damaged.
IMPORTANT: Store the unit indoors with
the power cord wrapped safely around the
tower.
This unit contains no serviceable
electrical parts. Do not attempt to
service the unit yourself.
Maintenance
Reassembly
The areas on the roller handle and the extension
indicated below must be cleaned thoroughly and
lubricated after each use.
ALL paint should be removed from the areas highlighted
in gray below, especially the quick-release tabs and all
other areas that connect with other parts. This can be
done by using the appropriate cleaning solution and an
old toothbrush.
Note: Make sure to clean all paint residue that may
remain from the Smart Edge Roller trim brush and
guard. Make sure to rotate the trim brush and clean any
paint residue that may have accumulated under it.
When all of the components have been throughly
cleaned and lubricated, you can now reassemble the
roller assembly and roller arm for storage.
1. Reassemble the cap and core into the roller cover.
2. Reattach the roller assembly (cap, core and cover) to
the roller arm.
3. Attach the spatter shield to the roller arm.
4. Press the quick-release tabs on the roller handle and
attach the the roller assembly to the roller handle.
IMPORTANT: Do not submerge roller handle.
In addition to thoroughly cleaning your unit after every
use, you must clean and lubricate the areas on the
roller arm, extension, and the Smart Edge Roller arm
indicated below. Use a thin layer of petroleum jelly to
lubricate the indicated areas.
Proper lubrication will prolong O-ring and seal life, and
keep your unit functioning smoothly.
Quick-
release
tabs
Quick-
release
tabs
Connecting
area
Connecting
area
Handle
Extension
O-ring
O-ring
Connecting
area
Seal
O-ring
Roller Arm
SMART Edge
Roller arm
Extension
Seal
Connecting area