Wagner Control Spray - Manual (Page 3)

3 English
Important Electrical Information
NOTICE
Use only a 3-wire extension cord that has a 3-blade grounding plug
and a 3-slot receptacle that will accept the plug on the product.
Make sure your extension cord is in good condition. When using
an extension cord, be sure to use one heavy enough to carry the
current your product will draw. An undersized cord will cause a
drop in line voltage resulting in loss of power and overheating. A 14
gauge (200 feet maximum) or 12 gauge cord (300 feet maximum) is
recommended. If an extension cord is to be used outdoors, it must
be marked with the suffix W-A after the cord type designation. For
example, a designation of SJTW-A would indicate that the cord
would be appropriate for outdoor use.
Grounding Instructions
This product must be grounded. In the event of an electrical short
circuit, grounding reduces the risk of electric shock by providing an
escape wire for the electric current. This product is equipped with a
cord having a grounding wire with an appropriate grounding plug.
The plug must be plugged into an outlet that is properly installed
and grounded in accordance with all local codes and ordinances.
DANGER--Improper installation of the
grounding plug can result in a risk of
electric shock.
If repair or replacement of the cord or plug is
necessary, do not connect the green grounding
wire to either flat blade terminal. The wire with insulation having a
green outer surface with or without yellow stripes is the grounding
wire and must be connected to the grounding pin.
Check with a qualified electrician or serviceman if the grounding
instructions are not completely understood, or if you are in doubt as
to whether the product is properly grounded. Do not modify the
plug provided. If the plug will not fit the outlet, have the proper
outlet installed by a qualified electrician.
This product is for use on a nominal 120 volt circuit and has a
grounding plug that looks like the plug illustrated below. Make sure
that the product is connected to an outlet having the same
configuration as the plug.
Grounded Outlet
Grounding Pin
Cover for grounded outlet box
Important Safety Information
• Read all safety information before
operating the equipment. Save these instructions
Components
Viscosity
cup
Handle
Filter
housing
Fluid
container
Turbine
Trigger
Material
adjustment
knob
Nut
Air cap Seal
Nozzle