Legacy Classic Furniture Nursery Crib Drawer 490-8910C - Manual (Page 2)

Assembly Instruction 490-8910 CRIB DRAWER
Page 2 of 5
HARDWARE ENCLOSED:
(H) Hex bolt screws: M6 x 20 – 2pcs
(K) Caster – 4pcs
TOOLS REQUIRED:
(M) Hex Allen Wrench with Ball tip -1pc (Included) Phillips Screwdriver (not included)
PRE-ASSEMBLY:

Remove all parts and hardware from the box and lay out on a clear carpeted or scratch-free work surface,
as this will avoid damaging parts during assembly. The shipping box provides an ideal work surface.

Do not dispose of any packaging or contents of the shipping carton until assembly is completed to avoid
accidentally discarding small parts or hardware.

Use the parts and hardware lists above to identify and separate each of the pieces included.

The illustrations provided allow for easier assembly when used in conjunction with the assembly
instructions.

The use of power tools for assembly is not recommended. Power tools can damage hardware or split
wood.
ASSEMBLY INSTRUCTIONS:
1. Lay out all the parts and hardware. Make sure the quantity of each is correct
2. Install the Cam Bolts into the hole of the Front Side (A) , the Right Side (D) and the Left Side panel (C).(See
Fig1)
(I) Cam bolt - 10pcs
(J) Cam nut - 10pcs
(L) Wooden Screw - 8pcs (N) Hex bolt screws M6 x 20 - 4pcs