Acer Altos R910 Series - Manual (Page 90)

3 System upgrade 80
RAID activation key
Removing the RAID activation key
1 Observe the ESD precautions and pre-installation instructions
described on page 33.
2 Remove the memory boards or memory air baffles from DIMM
slots C and D. See “Cold Removal of Memory Board” on page 70
and “Removing a memory board air baffle” on page 42.
3 If a PCI card is installed in PCI-X Slot 7, remove the card. For
instructions on removing a PCI card, see page 76.
4 Insert the tip of a small flat-bladed screwdriver under the plastic
tab on the retainer holding the activation key to the mainboard.
5 Gently push down to detach the activation key.
6 Store the activation key in an anti-static bag.
7 Replace the memory board air baffle.
8 Replace the PCI card.
9 Observe the post-installation instructions described on page 34.
Installing the RAID activation key
1 Observe the ESD precautions and pre-installation instructions
described on page 33.
2 Remove the memory boards or memory air baffles from DIMM
slots C and D. See “Cold Removal of Memory Board” on page 70
and “Removing a memory board air baffle” on page 42.
3 If a PCI card is installed in PCI-X Slot 7, remove the card. For
instructions on removing a PCI card, see page 76.
4 Remove the RAID activation key from its protective packaging.