Acnodes RMC 7182 - Manual (Page 78)

661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218
© Copyright 2005 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.
RMC 7182
1U Rackmount System
C-STATE Tech
If enabled, C-State is set by the system automatically to either C2, C3 or C4 state. The options are
Disabled and Enabled.
C-State package limit setting
If set to Auto, the AMI BIOS will automatically set the limit on the C-State package register. The options
are Auto, C1, C3, C6 and C7.
C1 Auto Demotion
When enabled, the CPU will conditionally demote C3, C6 or C7 requests to C1 based on un-core
auto-demote information. The options are Disabled and Enabled.
C3 Auto Demotion
When enabled, the CPU will conditionally demote C6 or C7 requests to C3 based on un-core auto-
demote information. The options are Disabled and Enabled.
DCA Technology
This feature accelerates the performance of TOE devices. Note: A TOE device is a specialized, dedi-
cated processor that is installed on an add-on card or a network card to handle some or all packet
processing of this add-on card. For this moth- erboard, the TOE device is built inside the ESB 2 South
Bridge chip. This feature is supported only by some types of processors (i.e., Intel Nehalem-WS 1S).
Theoptions are Enabled and Disabled.
DCA Prefetch Delay
A DCA Prefetch is used with TOE components to prefetch data in order to shorten execution cycles
and maximize data processing efficiency. Prefetching too fre- quently can saturate the cache direc-
tory and delay necessary cache accesses. This feature reduces or increases the frequency the system
prefetches data. The options are [8], [16], [32], [40], [48], [56], [64], [72], [80], [88], [96], [104], [112],
[120]
XAdvanced Chipset Control
The items included in the Advanced Settings submenu are listed below:
QPI Links Speed
Use this feature to select QPI data transfer speed. The options are Slow-mode, and Full Speed.
QPI Frequency
Use this option to set the QPI frequency. The options are Auto, 4.800 GT, 5.866
GT, and 6.400 GT.