Flytec SMS/Bluetooth set-up 6040/6030/6020 - Manual

Flytec Bluetooth Option
1/5 12.04.2011
I:\TU-Flytec\6000_Serie\Projekt 6020-30\Bluetooth\Bluetooth and SMS Setup Eng.doc
©
by Flytec AG, Nur fü
r internen
Gebr
auch
English
Setup Bluetooth
In order to use the Bluetooth/SMS option, the Bluetooth module must be installed and
tested by Flytec or Bräuniger. With the BT module installed and the SMS feature unlocked
the 6020/6030/6040/5020 and IQ Compeo+ /Competino+ /Competino can send SMS
position info using a Bluetooth-enabled mobile phone with DUN (Dial Up Network)
capability. Alternatively, NMEA strings can be sent using a Java enabled mobile phone
that is able to receive NMEA strings via Bluetooth with the help of a specialized Java
program. In this case the data is sent via SMS or GPRS to a phone number (e.g.,
Leonardo Live Server)
Requirements
• Flytec 5020/Competino with firmware v1.18 (or hiher), 6020/Competino+ with
firmware v3.07 (or higher), 6030/Compeo+ with v3.28 (or higher), 6040 with v2.05,
(or higher) and built-in Bluetooth module with option unlock code entered.
• GSM mobile phone with integrated Bluetooth interface with DUN profile. If you are
not sure if your mobile phone supports DUN you can check it with a Windows PDA,
Laptop or PC with Bluetooth. If you search for the services of your mobile phone
you should see “Dial-up Networking“.
General pairing procedure
To initiate a new pairing, the instrument must reset the Bluetooth system. There a 6 reset
phases. With these 6 phases, all recent pairings will be deleted and the module will
establish new connection in a Bluetooth network.
After the reset, the instrument will search for Bluetooth devices nearby for 30s to 60s. The
instrument can only receive a maximum of 12 Bluetooth devices. If more than 12 Bluetooth
devices are found, the instrument will display a warning to change location or to switch off
some devices to reduce the number of detected devices.
In Bluetooth Mode 1 NMEA -out (SPP Profile) the instrument starts directly in the
Bluetooth mode after quitting the setup menu. The pairing procedure must be started from
the Laptop, PC or Windows PDA. The Bluetooth driver on the PC side allocates a virtual
COM port. This COM port must be entered in the application on the PC side.
In Bluetooth Mode 2 SMS (DUN Profile), the pairing procedure must be initiated from the
instrument. It is not possible to pair it from the mobile phone. The Bluetooth function must
be enabled on the mobile phone before the pairing process is initiated on the instruments.
The mobile phone normally will show a small Bluetooth symbol when the Bluetooth
function is active. After reset and searching, up to 12 Bluetooth members will be listed on
the instrument. The user can chose the desired device and start the pairing.