LBL Lighting MEZZO GPCF - Manual (Page 3)

3
Install the Fixture
NOTE:
Make sure to support the fixture while
adjusting the aircraft cables. An assistant is
recommended to complete the remaining steps.
Feed the aircraft cables through the cable clutch in the
canopy.
Evenly pull the aircraft cable up through the canopy to
raise the fixture to the desired length.
Cut off the excess aircraft cable leaving enough for fine
leveling later.
Loosen the set screw in the strain relief and feed the
power cord from the fixture into the canopy port until it
is straight, then re-tighten the set screw.
NOTE:
This product does not support the “lazy cord”
look. This product was designed for a straight cord
look.
CABLE
CLUTCH
AIRCRAFT
CABLE
STRAIN RELIEF
CANOPY
POWER CORD
SET SCREW
Note: If the fixture has a cord with a cloth cover,
taping down the frayed end of the cloth may assist
in feeding it through the strain relief.
3B
Leave 6" of the cord behind the canopy for power
connections. Cut the excess cord.
From the end of the cord, strip the insulation 4" using a
sharp knife. . Make sure not to nick the inner wires
Strip the end of the wires.
Feed the fixture wires through the mounting plate
center hole and then pull them out of the electrical box.
Note: If the cord has a cloth cover, peel back or remove
the cloth where the secondary strain relief is installed.
Install the secondary strain relief by first feeding the
power cord through it.
Snap the strain relief tab into place.
Pull the cord to take up the slack and fit the rest of the
cord in the strain relief’s openings.
7
7
TAB
4"
6
Install the Canopy
5
4A
4B
4
2
3
1
5
6
7
2
3
5
4
2
4
4
4
3A
Take note of the wire connections and remove the wire
nuts to disconnect the power cord wires from the
ballast wires. 1