LBL Lighting MEZZO PCF - Manual (Page 2)

2
CORD
CANOPY
Adjust the fixture height (from bottom of the fixture
shade to top of the canopy) by moving the canopy and
strain relief up or down.
When the desired height is achieved, tighten the set
screw on the strain relief.
Mark the cord underneath the strain relief.
Install the Fixture
2C
SET SCREW
Loosen the set screw on the strain (Do Not Remove)
relief.
2B
2
3
4
5
4
3
Remove the strain relief from the housing by unscrewing
the housing cap and pulling the strain relief out.
2A
1
STRAIN RELIEF
HOUSING CAP
STRAIN RELIEF
HOUSING
Leave 6" of the cord behind the canopy for power
connections. Cut the excess cord.
From the end of the cord, strip the insulation 4" using a
sharp knife. . Make sure not to nick the inner wires
Strip the end of the wires.
Feed the fixture wires through the mounting plate
center hole and then pull them out of the electrical box.
Note: If the cord has a cloth cover, peel back or remove
the cloth where the secondary strain relief is installed.
Install the secondary strain relief by first feeding the
power cord through it.
Snap the strain relief tab into place.
Pull the cord to take up the slack and fit the rest of the
cord in the strain relief’s openings.
12
12
TAB
4"
11
10
2D
2E
9
7
8
6
10
11
12
9