LBL Lighting Juniper SFCF - Manual (Page 2)

2
Place the glass shade onto the socket bracket and align the
glass shade holes with socket bracket holes.
Tighten the three thumb screws through the glass shade holes
completely into the socket bracket holes to secure the glass
shade in place.
NOTE:
Do not over tighten the thumb screws which may
cause the glass shade to break.
GLASS SHADE
THUMB SCREW
SOCKET
BRACKET
(H)
GLASS SHADE
CANOPY
Determine the desired fixture height (From the bottom of
glass shade to the top of canopy).
Feed the cord into the canopy and plastic strain relief.
Adjust the fixture height and mark the cord below the canopy
bushing.
PLASTIC STRAIN RELIEF
CANOPY
CORD
BUSHING
MARKED LINE
PLASTIC STRAIN
RELIEF
1"
Feed the cord inside the canopy so that the marked line is
exposed behind the canopy.
Hold the plastic strain relief 1" above the marked line and
tighten the set screw.
7
1C
3
1E
1D
1F
5
8
6
7
4
6
7
3
4
4
8
9
9