LBL Lighting East River S - Manual (Page 3)

3
2 3
1
Connect the fixture to a suitable ground in accordance
with local electrical codes.
Connect the white driver wire to the neutral power line
wire with a wire nut.
Connect the black driver wire to the hot power line wire
with a wire nut.
Install the Fixture
4A
3
1
2
Adjust the aircraft cables until the fixture is level; feed
the cable into the cable clutch to raise the fixture and
push in on the cable clutch nipple to release the cable
and lower the fixture.
CABLE
CLUTCH CABLE
CLUTCH
6
4C
4B
6
4
5
NOTE: It is recommended that one person hold the
fixture while the electrician connects the power and
installs the canopy.
Tighten the cord screw.
From the end of the cord, strip the insulation 4" using a
sharp knife. . Make sure not to nick the inner wires
Cut off the extra cord, strip 1/2" off the wire ends, and
reconnect the power cord wires to their original
connections (reversal of 3A).
3C
6
7
5
7
6
5
MOUNTING
PLATE SCREW MOUNTING
PLATE SCREW
Place the driver, all wires, and wire nut connections
inside the canopy.
Align the canopy holes with the mounting plate holes.
Secure the canopy in place by tightening the four
mounting plate screws using the Allen wrench.
ALLEN
WRENCH