LBL Lighting Calix 7-Light - Manual (Page 3)

3
POWER
CORD
STRAIN
RELIEF
3B
SET SCREW
Loosen the 2 set screws on the strain (Do Not Remove)
relief.
Pull the power cords through the strain relief to the
desired length and re-tighten the 2 set screws.
Leave at least 6” of cord in the back of the canopy for
wire connections and trim off the excess cable.
From the end of the cord, strip the insulation 4" using a
sharp knife.
. Make sure not to nick the inner wires
Strip the end of the wires.
Reconnect the power cord wires to their original
connections to the driver (reversal of 2A).
3
4
2
5
6
7
Install the Canopy
4A
10 2 1
2 2
2 3
Ground the fixture to a suitable ground in accordance
with local electrical codes.
Connect the white driver wire to the neutral power line
wire.
Connect the black driver wire to the hot power line
wire.
3
2
3
1
POWER
CORD
DRIVER
3
4