LBL Lighting Constellation Grande S - Manual (Page 2)

2
Assemble the Fixture
2A
Loosen the two set screws on the stopper at the bottom
of the cable post aircraft cable using the provided Allen
wrench.
Determine the desired height of the fixture, move the
stopper to the determined location, and tighten the two
set screws on the stopper.
Take note of the NOTE:
height measurement, it will be needed for the canopy
aircraft cable.
Cut off the excess aircraft cable.
Ensure that the rubber grommet is in place and install
the separate aircraft cable into the shade.
Feed the open end through the small hole in the shade
and pull it all the way through until the stopper is
reached.
2 1
2 2
2 3
2 4
2 5
SET SCREW
STOPPER
RUBBER
GROMMET
AIRCRAFT
CABLE
SHADE
2B
LAMP
SOCKET
Screw the lamp into the socket.
Use MAX 75 Watt type A19
medium base incandescent lamp.
C AUTION:To reduce the risk of a burn or electric shock
during relamping, disconnect the power to the fixture.
1 6
2C
SHADE
Place the socket assembly inside the shade.
Ensure that the cushion pads are in place and insert the
bracket into the shade by slightly rotating it into place. 2 8
2 9
2 10
5
3
4
BRACKET
SOCKET
ASSEMBLY
Place the socket nipple through the bracket hole and
pull the assembly up until it rests inside the top of the
shade.
Place the cover over the top of the shade opening lip,
ensure that the bracket is centered and is gripping the
shade properly, and secure it all by screwing on and
tightening the cap.
2D
CAP
COVER
NIPPLE
BRACKET
CUSHION
PAD
7
7
8
10