LBL Lighting Constellation Chandelier - Manual (Page 3)

3
Install the Lamps and Glass
LAMP
Push the lamp pins completely into the socket holes.
Repeat for each socket.
NOTE: Use only your fingers and a soft cloth to install
the lamp.
SOCKET
Use Frosted Bi-pin MAX 35 Watt
Xenon Lamp in each socket.
Refer to the diagrams on the back page to determine the
location of the glass piece.There are two different sizes of
glass: large and small.
Push the glass opening completely onto the grooved glass
holder.The glass should fit snugly on the holder. If holder is too
big for the opening or the glass fits loosely on the holder,
follow step 4 to adjust the holder.
SUPPORT
CABLE
GROOVED
GLASS HOLDER
GLASS
3A
1
3B
2
3
3
1
Push in the cable clutch nipple and feed in the support cable
from the glass.
Adjust the support cable until the glass is level. Feed the cable
into the cable clutch to raise the glass. Push in on the cable
clutch nipple to release the cable and lower the glass.
Repeat steps 1 through 4 for all the other glass pieces.
CABLE
CLUTCH
NIPPLE
SUPPORT
CABLE
NOTE: Bend the tabs carefully. Excessive bending may
break the tabs.
To adjust the glass holder (if necessary), bend the tabs in or out
slightly with needlenose pliers.
NEEDLENOSE
PLIERS
TABS
4
5
3C
3D
6
7
6
4