Install the fixture, Save these instructions – LBL Lighting Miss Charlie User Manual
Page 2
2
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2012 LBL Lighting.All rights reserved.The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
3C
2
6
2
7
3D
2
9
3A
2
Screw all four lamps into the sockets.
1
CAUTION: To reduce the risk of a burn or electric
shock during relamping, disconnect the power to
the fixture.
Use
Type A19 Medium Base Lamp.
120 volt
MAX
75
Watt
Connect the fixture to a suitable ground in accordance
with local electrical codes.
Connect the black fixture wire to the hot power line wire
with a wire nut.
Connect the white fixture wire to the neutral power line
wire with a wire nut.
2
8
SCREW
ALLEN
WRENCH
Place all wire and wire nut connections inside the
canopy.
Align the canopy holes with the crossbar holes. Secure
the canopy in place by tightening the four screws with
the provided Allen wrench.
2
10
LAMP
SOCKET
3B
AIRCRAFT
CABLE
CABLE
CLUTCH
SHADE
Feed the aircraft cables through the cable clutches in
the canopy.
Pull the aircraft cable up through the canopy to raise
the shade. Make sure that the shade is at least 3.5”
away from the lamp, but high enough to cover the
lamps.
To lower the shade, push the cable clutch in and pull the
aircraft cable down.
When the shade is in the desired position, trim the
excess aircraft cable.
NOTE:
Make sure to support the shade while
adjusting the aircraft cables. An assistant is
recommended to complete the remaining steps.
2
2
2
3
2
4
2
5
NOTE:
To replace the lamps, simply reach the lamp
from top of the glass shade.
DO NOT REMOVE THE
SHADE.
Install the Fixture
7
8
6