LBL Lighting Veneto Grande SP - Manual (Page 3)

3
Install the Fixture
2A
1
#8-32 SCREW
CROSSBAR
1
1
Install the Lamp
Use MAX 120 Volt, 150 Watt Type E11
Base Mini Candelabra Lamp.
C AUTION: To reduce the risk of a burn or electric shock
during relamping, disconnect the power to the fixture.
NOTE: Use only your fingers and a soft cloth to replace
the lamp.
Carefully swing the socket assembly out of the glass shade.
Screw the lamp completely into the socket. 2
1
Mount the crossbar to the electrical box with the provided
two #8-32 screws.
LAMP
SOCKET
3A
2
1
2B
Connect the fixture bare wire and the crossbar green wire to
the ground in accordance with local electrical codes.
Connect the fixture black wire to the hot power line wire with
a wire nut.
Connect the fixture white wire to the neutral power line wire
with a wire nut.
2
3
4
2
3 4
NOTE: To ease the installation, it is recommended to
remove the glass shade by unscrewing the cable bushings
(refer to drawing 1E).
Place all wire and wire nut connections inside the electrical
box.
Align the canopy holes with the crossbar holes. Secure the
canopy in place by tightening the two M5 button head screws
with the provided 2.5MM Allen wrench.
Tighten the three aircraft cable bushings to the glass shade cap
screws (refer to step 11 and figure 1E on page 2).
5
6
2.5MM ALLEN
WRENCH
M5 BUTTON
HEAD SCREW
5
6
6
2C
7