LBL Lighting Twilight 20 Chandelier - Manual (Page 3)

3
L
M
S
L
L
L M
M
M
M
S
S
S
S
S
S
S
S
S
L
Install the Fixture Arms for 20 Light
Insert the arm of a long socket assembly into one of the
bottom hub holes and tighten the M3 set screw with the
provided 1.5 MM Allen wrench.
Feed the stripped portion of the long socket assembly wire
into the provided metal sleeve, and into the nearest "L" port
onto the hub plate. Tighten the M4 set screw with the 2 MM
Allen wrench.
Repeat steps 1 & 2 for the remaining four long socket assembly
wires.
Repeat steps 1 through 3, using the medium socket assembly
wires middle hub, and the "M" posts on the hub plate.
Repeat steps 1 through 3, using the short socket assembly wire
top hub and the "S" posts on the hub plate.
M4 SET
SCREW
2MM ALLEN
WRENCH
METAL
SLEEVE
L = Long Socket Assembly Wire
M = Medium Socket Assembly Wire
S = Short Socket Assembly Wire
HUB PLATE
WIRE
ASSEMBLY
WIRE
ASSEMBLY
"L" POST
HUB
ARM
NOTE: This section is for the installation of the arms
for the 20 light version. Skip to the section 4 for the 12
light version.
3A
1
2
3
4
5
5
4
2
2
5
4
3