Assembling the fixture arms, 2b 2c 2d – LBL Lighting Tubes 7 SP User Manual
Page 3
3
(H)
Assembling the Fixture Arms
The overall fixture height (H) is measured from bottom of the
bottom glass shade to the end of the fixture Fusion Jack.
Determine the overall desired fixture height.The height (H1) is
from the bottom of the top shade to the end of the fixture
Fusion Jack.
GLASS SHADE
FIXTURE
FUSION
JACK
(H1)
M3 SET
SCREW
1.5 MM
ALLEN
WRENCH
Loosen
the four M3 set screws on the
(Do Not Remove)
socket assembly rods.
Loosen
the two M3 set screws on the
(Do Not Remove)
sides of the Fusion Jack assembly rod with the provided
1.5 MM Allen Wrench.
M3 SET SCREW
1.5 MM ALLEN
WRENCH
FUSION JACK
ASSEMBLY ROD
M3 SET
SCREW
FIXTURE ROD
Insert the two fixture rods on the opposite side of socket pin
holes, completely into the socket assembly rod and secure into
place by tightening the M3 set screws with the provided
1.5 MM Allen wrench.
1.5 MM ALLEN
WRENCH
SOCKET
ASSEMBLY
ROD
SOCKET
PINHOLE
NOTE: Save the number on the packaging to later
install to canopy for proper orientation.
NOTE: The fixture arms vary in lengths follow
steps 1-13 for a typical installation.
Optional: The Fixture Rods can be field cuttable to
a desired Height.
2A
1
1
2
3
4
2B
2C
2D
4
2
2
2
2
3
3
4