LBL Lighting Neutron P - Manual (Page 2)

2
FIXTURE HOUSING
GLASS SHADE
Push the grooved section of the acrylic shade into the fixture
housing.
Ensure that the groove is aligned with the set screws and
tighten the three M4 set screws with the provided 2MM Allen
wrench; alternate screws before tightening all the way to
ensure that the shade remains centered.
2 MM ALLEN
WRENCH
M4 SET SCREW
NOTE: Do not clean the acrylic shade with alcohol or
alcohol base cleaners which will damage the shade.
Adjust the Fixture Height
1D
5
6
GROOVE
FIXTURE HOUSING
2MM ALLEN
WRENCH M4 SET SCREW
Loosen (DO NOT REMOVE) the three M4 set screws on
the fixture housing with the provided 2MM Allen wrench.
Insert the lamp protection ring completely against the lamp.
1C
3
4
LAMP
PROTECTION RING
Back out (do not remove) the set screw on tip of the
connector with the provided Allen wrench.
Back out (do not remove) the set screw on the conical
connector with the provided Allen wrench.
SET SCREW
ALLEN WRENCH
2
2A
2B
2
1
SET SCREW
ALLEN WRENCH
1
CONNECTOR
2C
Cut the coaxial cable to the desired length.
Gently twist the end of the coaxial cable between thumb and
forefinger.
4
3
4