LBL Lighting Straight Monorail - Manual (Page 2)

2
CIRCULAR
PLYWOOD
MONORAIL
Start bending the rest of the Monorail against the circular
plywood until the desired curve or circle is achieved.
HOOK
ARM
PEDAL
MONORAIL
Wiremold Pipe Bender (Horizontal
or Vertical Bend)
Feed the Monorail through the Pipe Bender hook. Start
bending the Monorail by gently pulling back on the arm of the
Pipe Bender.
Start with small angle (MAX 10°) to avoid errors in shaping
the Monorail.After each bend unhook and check the Monorail
against the pattern.
NOTE: The Wiremold Pipe Bender can be used to create
smooth horizontal curve of 90° or less.Avoid stepping on
the pedal of the Pipe Bender which will flatten and damage
the Monorail.
CONDUCTIVE OR ISOLATING
JOIN CONNECTORS
MONORAIL
Freestyle Bending (Horizontal Bend
Only)
CENTER OF
BENDING SECTION
PUSH PUSH
Choose the center of bending section on the Monorail.The
bending point should be centered between the hands.
To ensure a smooth curve, begin with hands as far as apart as
possible, moving the hands closer together as bending
progresses. Bend the Monorail until the desired shape is
achieved.
Connecting the Monorail Sections
Push two Monorail sections completely onto the conductive
or isolating join connectors.
Tighten the M3 set screws with the 1.5 MM Allen wrench
provided. Make sure that the set screw connection for
conductive connector is tight to avoid heat build up and
corrosion. For the isolating connector, tighten the #6-32 set
screw firmly to avoid stripping the thread.
M3 SET SCREW
1.5 MM ALLEN
WRENCH
MONORAIL
6
1B 1A 4A 2B
6
1
1
1A 3A
2
1
2
1
2
1A 5A
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved.The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company A Generation Brands Company
2
1 2
1
2
2 1