Save these instructions – LBL Lighting Mademoiselle User Manual
Page 2
1C
With the Allen wrench provided, back out (do not fully
remove) the set screw at the base of the fixture.
1D
Properly place the driver, all wires, and wire nut
connections into the electrical box.
Hook the top of the fixture to the top of the mounting
plate and swing the bottom of the fixture toward the
plate until it is flush with the wall.
Tighten the set screw at the bottom of the fixture.
6
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved.The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
SAVE THESE INSTRUCTIONS!
2
7
SET SCREW
ALLEN WRENCH
SET SCREW
5
ALLEN WRENCH
8
8
5
NOTE: This fixture can be installed upside down.
1E
Install the mesh onto the fixture by draping it over the
LED panel.
For double layered mesh, add a second mesh.
9
10
NOTE: Drape the mesh according to preference. For
images, see our catalog or visit www.lbllighting.com
9