Install the lamp & shade, Save these instructions, 2a 1c – LBL Lighting Juniper WCF8 User Manual
Page 2
2A
1C
Place all wires and wire nut connections properly inside the
electrical box.
Slide the mounting plate center hole onto the exposed
threaded nipple. Secure the mounting plate in place by tighten
the provided nut and washer to threaded nipple.
2
MOUNTING
PLATE
NUT
WASHER
Install each lamp by pushing the lamp pins completely into the
socket holes.
Install the Lamp & Shade
LAMP
Use
Watt Type Quad Tube
MAX 18
G24q-2 Base Compact Fluorescent
Lamp With Each Socket.
LAMP PIN
SOCKET
Place the glass shade onto the mounting plate. Align the glass
shade holes with the mounting plate holes. Tighten the thumb
screws to secure the glass shade in place.
NOTE:
Do not over tighten the thumb screws which may
cause the glass shade to break.
GLASS SHADE
THUMB
SCREW
MOUNTING PLATE
THREADED
NIPPLE
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved.The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
6
7
1
7
2B
2
2
2