Install the lamp & shade, Save these instructions – LBL Lighting Linear W User Manual
Page 2
MOUNTING
PLATE
Place all wires and wire nut connections properly inside the
electrical box.
Slide the mounting plate center hole onto the exposed
threaded nipple. Secure the mounting plate in place by
tightening the cap to threaded nipple.
CAP
2
EXPOSED THREADED
NIPPLE
Install the Lamp & Shade
Use
120 Volt,
Watt Type T4,
MAX
60
G9 Base, Bi-Pin Halogen Lamp.
Push the lamp completely into the socket.
NOTE: The G9 lamp has an integral glass envelope and is
thus safe to be used without a lamp shield.
PIN
LAMP
SOCKET
GLASS
SHADE
Place the glass shade onto the mounting plate. Align the glass
shade holes with the mounting plate holes. Tighten the thumb
screws to secure the glass shade in place.
NOTE:
Do not over tighten the thumb screws which may
cause the glass shade to break.
THUMB
SCREW
MOUNTING
PLATE
6
1C
7
2
2B
2
2
7
1
1
2A
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved.The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company