LBL Lighting Max - Manual (Page 2)

1D
1C
2
Connect the backplate to a suitable ground in accordance with
local electrical codes.
Connect the fixture white wire to the neutral power line wire
with a wire nut.
Connect the fixture black wire to the hot power line wire with
a wire nut.
Place all wires and wire nut connections properly inside the
electrical box.
Place the fixture canopy onto the backplate. Level the fixture
vertically and tighten the two M3 set screws with the 1.5MM
Allen wrench to secure the fixture in place.
CANOPY
M3 SET SCREW
1.5MM ALLEN WRENCH
Install the Lamp & Shade
SOCKET
LAMP
Push the lamp pins completely into the socket holes.
NOTE: Use only your fingers and a soft cloth to install
the lamp.
Use 120 Volt, Watt Type T4, MAX 60
G9 Base, Bi-Pin Halogen Lamp.
5
6
7
7
9
9
6
1
2A
1
8