Install the lamps & shade, Save these instructions, 2a 2b – LBL Lighting Teardrop WCF User Manual
Page 2
2A
2B
MOUNTING PLATE
Place all wires and wire nut connections properly inside the
electrical box.
Slide the mounting plate center hole onto the exposed
threaded nipple. Secure the mounting plate in place by
tightening the cap to threaded nipple.
CAP
2
EXPOSED THREADED
NIPPLE
Push the lamp pins completely into the socket holes.
Use
Watts Type Quad G24q-1
MAX 13
Base Compact Fluorescent Lamp.
Install the Lamps & Shade
LAMP
SOCKET
LAMP PIN
GLASS
SHADE
Place the glass shade onto the mounting plate. Align the glass
shade holes with the mounting plate holes. Tighten the thumb
screws to secure the glass shade in place.
THUMB
SCREW
MOUNTING
PLATE
MOUNTING
BRACKET
NOTE:
Do not over tighten the thumb screws which may
cause the glass shade to break.
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved.The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
1C
6
2
7
1
1
7
2
2